This book proposes a linear two-port model for an N-stage modified-Greinacher full wave rectifier, predicting the overall conversion efficiency at low power levels. Includes a procedure for measuring how impedance modulation in the tag affects signal at the reader, and other useful tools.

Radio Frequency Identification (RFID) is an automatic identification method relying on small chips and antennas. This book examines the analysis, design and optimization of UHF passive RFID systems for long-range applications. It presents a linear two-port model for an N-stage modified-Greinacher full wave rectifier, predicting the overall conversion efficiency at low power levels where the diodes are operating near their threshold voltage. The output electrical behavior of the rectifier is calculated as a function of the received power and the antenna parameters, and the two-port parameters values are computed for particular input voltages and output currents for the complete N-stage rectifier circuit using only the measured I-V and C-V characteristics of a single diode. Included is an experimental procedure to measure how impedance modulation in the tag affects the signal at the reader, and a useful tool for choosing the most appropriate impedances.

Texte du rabat

Radio Frequency Identification (RFID) is an automatic identification method, relying on storing and remotely retrieving data using devices called RFID tags or transponders. An RFID tag is an object that can be attached to or incorporated into a product, animal, or person for the purpose of identification using radio waves. Chip-based RFID tags contain silicon chips and antennas. Active tags require an internal power source, while passive tags do not.

Design and Optimization of UHF RFID Systems considers the analysis, design and optimization of UHF passive RFID systems for long-range applications. There are many key aspects thoroughly described in the text:

Wireless power transmission
Tag-to-reader backscattering communication
Reader and tag architectures and IC design.

Wireless power transmission is studied using a rectifier (a fundamental tag building-block) for which there has been a proven prediction model developed. Proposed is a theoretical analysis of possible backscattering modulations, as well as an experimental procedure to measure how the impedance modulation at the tag side, affects the signal at the reader. Finally, a complete tag design achieving a read range of 12 m at 2.45 GHz (4 W EIRP) is provided. At the time of writing, the results of this design outperform any other available IC tag.

Contenu
Wireless Power Transmission.- Analysis of the Modified-Greinacher Rectifier.- to RFID.- Backscattering architecture and choice of modulation type.- Backscattering modulation analysis.- RFID Tag design.- High frequency interrogator architecture and analysis.- Conclusion.